Shrink chuck 3° SK 40 - 10 - 120

Shrink chuck 3° SK 40 - 10 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- Absolute/incremental measurement

Standard (over 25mm range)

Quick change adaptors without safety clutch can be interchanged

For mounting tools with straight shanks

- Metric-inch conversion at any position

For d = 60 only with four fi xation screws according to DIN 912

With ER-Mini-nut

For machining centres with synchronous spindle

E2= 28 pieces

Thread configuration with a special design

3 µm radial run-out with a 2 µm clamping nut

for clamping holders with coolant channels directly to the cutting edge