28mm Blow Off Valve return blocker

28mm Blow Off Valve return blockerThe GKTECH Blow Off Valve return blocker and is to be used on the intake pipe when the standard blow off valve is removed. If the hole left from removing the blow off valve isn't removed, air will get sucked into the intake after the air flow meter and the car will run very rough. 1 piece billet aluminium construction Direct replacement 28mm's in diameter

The ultimate adjustable width set of spacers

Sold as a pair these wheel adapters bolt on to your standard hub just like a normal wheel spacer however 1 of your standard studs is then replaced with a longer stud which runs through the adapter and acts as the 5th stud

NOTE: These may require notching to the early model steering racks

straight line and cornering of your vehicle will be improved

HFM Two piece rotor offers a significant weight saving

- Raised roll center height for better handling

24 hour salt corrosion resistance test

NOTE#2: If you are running S14/S15 knuckles in your car then you will need the S14/S15 RC correction kit as these are knuckle specific

aswell as R33/R34 rear subframe in your R32

Want to install an aftermarket coolant temp sensor but don't want to cut into your radiator hose

- Replacement for Nissan part 14036-75F00

If your handbrake is mounted behind the shifter